friction conditions meaning in Chinese
摩擦条件
Examples
- Design of tire fault observer based on estimation of tire road friction conditions
路面磨擦状况估计的轮胎故障观测器设计 - The effect of the friction condition including the load and the sliding velocity on the wear of the composites was studied under water - lubricated condition and dry condition
本文还讨论了在水润滑与干摩擦条件下，载荷与滑动速率对纳米复合材料摩擦磨损性能的影响。 - Squeeze flow between two parallel disks is considered for small gaps for rigid - plastic material with partial wall slip . firstly , the coulombic friction condition is discussed , and a new pressure distribution is obtained
首先对现有的库仑摩擦条件下的压力规律做了进一步的研究，找到了一种更合理的圆盘上的压力分布规律。 - Based on the tribological principle and the theory of contact mechanics , it is feasible to adopt curvature - changing structure in the rock - bit journal bearing system . the structure and coupling relationship of curvature - changing journal bearing under the condition without friction have been analyzed and three kinds of sub - form structure configurations , namely , the pseudo - curvature - changing structure , the conformable curvature - changing structure , and the clearance curvature - changing structure , been differentiated according to the contacting features . the shape optimization and pre - running - in regulations of the contact surface of curvature - changing journal bearing under friction condition have been established . the results of rock bit journal bearing test indicate that the tribological behavior of the bearing can be effectively improved by curvature change based on both designing and pre - running - in
基于摩擦学原理和接触力学理论,提出了可在牙轮钻头滑动轴承中采用变曲率结构.在不考虑摩擦的情况下，就结构设计和配合关系等问题进行了分析讨论，划分了准变曲率、吻合变曲率以及间隙变曲率等3种结构形式；针对考虑摩擦时的变曲率结构，提出了接触形状优化和预磨合的实施方案.钻头轴承试验结果表明，无论是预设计变曲率还是预磨合变曲率，都能改善轴承摩擦副的摩擦学特性，因而值得进一步研究和推广 - And also , the wear resistance at ambient temperature and of za27 alloyed with mn when lightly loaded is desirable but becomes worse at high temperature . the wear mechanism of the one mixed with both adhesive and abrasive wear under sliding friction conditions ( at high temperature )
Si的加入量为1 - 3时， za27合金的磨损量最少，高温摩擦性能最好；加入mn后， za27合金在低温轻载下耐磨性能较好，高温耐磨性能不理想；在滑动摩擦条件下(高温)的磨损以粘着磨损和磨料磨损两种方式共同存在。